The CNC sponge cutting machine of Nantong Zhigu CNC Machinery Co., Ltd. uses a computer to realize automatic operation. There are many control details that need to be paid attention to during the cutting process. The following Nantong Zhigu CNC Machinery Co., Ltd. will describe the operation steps of the CNC sponge cutting machine in detail , In order to facilitate the user's use of reference:

1. Close the switch inside the power supply.

2. Turn on the power lock on the operating host, press the power button, and plug in the CNC; turn on the dust collector and check whether the indicator light on the control box panel is operating normally.

3. Test operation, confirm that the switches and buttons on the panel are flexible and reliable. Check whether the ash unloading flapper valve is normal; reliably check whether the ash unloading flapper valve is normal;

4, CNC performs internal self-diagnosis and confirms that there is no error message displayed.

5. Close the switch in the servo motor cabinet, press the servo on button on the operation panel to supply power to the servo system, turn the pulse knob on the control panel to the on position to backflush the filter cartridge, and check whether the pulse is normal.

6. ​​Test run the machine to confirm that the various indicators of the machine run smoothly, and the limit and emergency buttons are reliable.

The above is the preparation work before starting up, let's introduce the detailed steps when cutting.

Prepare dry, clean, and non-deformed sponge raw materials;

Determine the single cutting moment, synchronous or symmetrical marking, and prepare the corresponding cutting moment;

Select the corresponding OK button on the operation panel;

Choose the appropriate knife belt according to the width of the line to be marked;

The "Mode" key on the operation panel is selected as "Draw Line"; call up the graphics to be drawn; start to draw; if the effect of a certain section of the line is not satisfactory, you can press the "Return" key to execute the program in reverse, and execute to When the point needs to be re-lined, press the "Return" key to re-line; after the end of the line.

After drawing the picture with CAD, directly pull it to the control panel, and then it can be automatically cut!

Whether it is necessary to check whether the equipment is operating normally during cutting, if an abnormality is found, press the emergency stop switch immediately!